Thingmagic M5e-Compact Manual do Utilizador descarregar pdf (Página 160)

Set Application Commands

160 Command Set

This example sets the GPIO Output #1 to ‘1’ (high). To get the current status of the GPIO

output pins, send the same command, with the length set to 0:

The response looks similar to the Get User GPIO Inputs command:

Set Current Region (97h)

The Set Current Region command sets the current region for use in the reader. The list

of region codes are found in Region code

s. See Regional Support for more information on

regional functionality.

Setting the region performs the following:

1. Frequency hop table is set to the default for the region.

2. Any other region specific settings are set (i.e. LBT) to default values unless otherwise

specified. Currently only LBT is configurable for regions supporting it.

The Set Current Region command supports two command syntaxes:

 The basic syntax for all regions where only the region code is specified. For example,

to set the region to KR:

 The extended syntax allowing the region code plus LBT Enabled (if supported by

Region) to be set. For example, to set the Region to EU3 and Enable LBT:

FF 00 96 1D 99

SOH Length OpCode CRC

FF 02 96 00 00 00 01 29 E0

SOH Length OpCode Status Output #1 Output #2 CRC

FF 01 97 03 4B BE

SOH Length OpCode Region CRC

FF 02 97 08 01 19 FD

SOH Length OpCode Region LBT Enable CRC

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 251 252

Sem comentários

Thingmagic M5e-Compact Manual do Utilizador Página 160